Функция вывода на автопилот сделана в экспериментальных целях. Не
используйте ее для ведения ваших
транспортных средств без присмотра.
Функциональность в текущей версии
OziExplorer не протестирована до
удовлетворительного уровня.
The Auto Pilot output option is turned on using the options on the Comm tab in the
Configuration dialog.
Outputs the Standard NMEA sentences which can control an Autopilot. The sentences
output are $GPRMC, $GPRMB and $GPAPB. You must check if these sentences are compatible
with your Autopilot.
The sentences being output can be viewed by selecting the Show NMEA Output to
Autopilot option on the Navigation Menu. You must be in active moving map
(tracking) mode and also be navigating for the outputs to be valid.
The sentences are output each time a sentence is received from the GPS.
The output also functions when using the NMEA simulator in OziExplorer so this could be
used for testing its operation.
The NMEA strings only contain valid navigational information if you are navigating
along a route or to a waypoint. Otherwise the parameters in the strings are empty.
The most common connection is where the GPS and Autopilot share the same serial port,
this is a diagram of a typical cable connection.
[ содержание ]
